Switching The Machine On And Off; Operation; Maintenance Changing The Carbon Brushes - Westfalia S1T-SW3 -76 Bedienungsanleitung

Switching the Machine ON and OFF

1. To switch on the machine, depress the ON/OFF Trigger (E).
2. If the machine is required to run for an extended period, push the locking
pin (F) in the handgrip, while holding the ON/OFF trigger in the "ON" posi-
tion.
3. To switch off the machine, press the ON/OFF trigger again. The locking
pin moves back. Now release the ON/OFF trigger.
After switching off and before putting down the machine, allow the motor
come to a complete standstill.

Operation

1. Always hold the machine with both hands, gripping each of the two sepa-
rate handgrips (A and K) simultaneously, using one hand on each.
2. Do not place the machine onto the working surface immediately. First
switch on the machine and allow the motor to run up to full speed.
3. Then place the sanding belt onto the working surface and start sanding.
4. Do not apply excessive pressure. Allow the sanding paper do the job.
Never sand magnetic objects!
To ensure efficient dust removal, empty the dust collection bag in regular
intervals.
Never remove sanding dust from the working surface by hand. Always use
a tool appropriate for this purpose, such as a hand-brush, cloth or brush,
depending on the material and the coarseness of the sanding dust.
Maintenance
Changing the Carbon Brushes
The carbon brushes should only be changed by an authorized technician! An
indicator that the carbon brushes need to be changed is when the motor runs
irregularly, with strong sparks observed as coming from the brush contacts.
1. Disconnect the machine from the mains!
Maintenance and Cleaning
8