Servicing The Product; Technical Data; Disposing Of The Product - Grundfos LiqTec Montage- Und Betriebsanleitung

6. Servicing the product

The product cannot be repaired. It must be replaced
with a new one. Contact Grundfos.

7. Technical data

66.5
Fig. 3 Dimensions for LiqTec
Supply voltage
230 VAC, 50/60 Hz.
Information related to IEC 61010-1
• Software class A.
• Pollution degree 2.
• Type 1.
LiqTec has been cURus approved according to
UL 508.
LiqTec
Maximum ambient temperature: +55 °C.
Power consumption:
Enclosure class:
Sensor
Maximum pressure:
Maximum liquid temperature:
Maximum cable length:
Standard cable:
Extension cable:
Product number:
Alarm/Run relay output
Potential-free changeover contact.
Maximum contact load:
250 V, 1 A, AC (inductive load).
Terminals
All terminals are suitable for conductors of 0.5 to
2
2.5 mm or AWG 20-13.
Cables
All cables must be rated minimum 70 °C.
Supply fuse
Maximum 8 A.
90
9 VA.
IP20.
40 bar.
+130 °C.
20 metres.
5 metres.
15 metres.
96443676.

8. Disposing of the product

This product or parts of it must be disposed of in an
environmentally sound way:
1. Use the public or private waste collection service.
2. If this is not possible, contact the nearest
Grundfos company or service workshop.
The crossed-out wheelie bin symbol on
a product means that it must be
disposed of separately from household
waste. When a product marked with this
symbol reaches its end of life, take it to a
collection point designated by the local
waste disposal authorities. The separate collection
and recycling of such products will help protect the
environment and human health.
See also end-of-life information at
www.grundfos.com/product-recycling.
9