Niko 10-589 Bedienungsanleitung Seite 14

10-589
2
➥
Mount the rear panel on the wall using suitable screws.
3
➥
Connect the wiring as indicated on the wiring diagram on page 18.
Note
• In one system, use the same colour code for the same terminals (a, b, P...) for all products of the Access Control Standard range.
• The metal cover can be earthed at terminal
4
➥
If the system includes multiple internal units, configure the terminal resistor via jumper J2 on the inside of the front panel. The default position
of J2 is not connected.
This internal unit is not the last device. J2 in not connected.
This internal unit is the last device: J2 is connected.
14
➥ 5
Connect the front panel to the rear panel using the connecting cable.
➥ 6
To close the video internal unit, place the front panel on the rear panel. Both panels are
held together by powerful magnets.
orientation arrow indicating the mounting direction
terminals for connection of the wiring
mounting hole for the incoming cable
EN