Operation - Worx WA0222 Originalbetriebsanleitung

TENSIONING CHAIN
Place the saw on any suitable
flat surface. And turn the Chain
Tensioning Knob clockwise until it is
hand tight.
NOTE: The tension is automatically
increased while the Chain Tensioning
Knob is being turned in a clockwise
direction.
WARNING: The chain is not
yet tensioned. Tensioning
the chain applies as described
under "TENSIONING CHAIN". The
chain now needs to be inspected
to make sure it is properly
tensioned.
NOTE: New saw chains will stretch.
Check the chain tension frequently
when first used and tighten when
the Chain becomes loose around the
Guide Bar.
WARNING:
• Removing the battery pack
before adjusting saw chain
tension.
• Cutting edges on chain are
sharp. Use protective gloves
when handling chain.
• Maintain proper chain tension
always. A loose chain will
increase the risk of kickback.
A loose chain may jump out of
guide bar groove. This may injure
operator and damage chain. A
loose chain will cause chain, bar,
and sprocket to wear rapidly.
NOTE: The Chain is properly
tensioned when it can be lifted off
of the Guide Bar and the drivelink is
within the rail of the Guide Bar.
NOTE: The Chain will stretch while
cutting and lose proper tension. When
the chain becomes loose, completely
unscrew the Chain Tensioning Knob,
that is, to turn it in a counter-clockwise
direction. And retighten it again.
Assembling the extension pole to
the machine
Connecting the extension pole to the
pole saw.
NOTE: Make sure the extension
pole is locked into position
securely before operation.
Attaching the shoulder strap
Attach the shoulder strap to the
hook on the pole with the included
carabiner hook.
Pole saw attachment
Filling the oil tank
WARNING: Removing the battery
pack before filling the oil tank.
1. Set the saw on any suitable surface
with Oil Filler Cap facing upward.
2. Clean area around the Oil Filler
Cap with cloth and unscrew the cap
by turning it counter clockwise.
3. Add bar and chain oil (not
included) until tank is full.
4. Avoid dirt or debris entering oil
tank, refit Oil Filler Cap and tighten
by turning clockwise until hand tight.
Important: To allow venting of the
oil tank, small breather channels
are provided between the Oil Filler
Cap and the strainer, to prevent
leakage, and ensure machine is left
in a horizontal position (Oil Filler Cap
uppermost) when not in use.
It is important to use only the
recommended standard bar and
chain oil (Grade: ISO VG32) to avoid
See Fig. C
damage to the pole saw. This can
be found at the location where you
purchased this saw or your local
hardware store. Never use recycled/
old oil. Use of non-approved oil will
void the warranty.
Do not swallow. If swallowed, call a
physician immediately. Keep out of
reach of children. Store away from
heat or open flame.

OPERATION

Cutting
LUBRICATION
Important: The pole saw is not filled with oil. It is
essential to fill with oil before use. Never operate the
pole saw without chain oil or at an empty oil tank
level, as this will result in extensive damage to the
product.
NOTE: Chain life and cutting capacity depend
on optimum lubrication. Therefore, the chain is
automatically oiled during operation.
CUTTING
Important: Check the oil tank is filled
See Fig. D
prior to starting and regularly during
operation. Refill oil when oil level is low. A full
oil tank will last approx. 35 minutes of cutting
depending on sawing intensity and stops.
Check recent replaced chain tension about
every 10 minutes during operation.
See Fig. E
(1) Installing the battery pack into the machine.
(2) Make sure section of log to be cut is not laying
on the ground. This will keep the chain from
touching the ground as it cuts through the log.
See Fig. F
11
See Fig. G
EN