Reset Button; Transportation And Storage - Ryobi R18AC Originalanleitung

WARNING
Always remove the battery pack from the tool when you
pack will prevent accidental starting that could cause
WARNING
Do not use in an environment which is dusty or otherwise
contaminated. Using the air compressor in this type of
environment may cause damage to the product.
Adjusting the air pressure
See page 197.
1.
and the battery pack is removed.
2. Connect the battery pack to the product.
3. Press the
Pull the pressure regulator knob outward to enable
5.
Turning the knob clockwise increases air pressure
at the outlet. Turning counterclockwise reduces air
pressure at the outlet. Push the pressure regulator knob
6. Following all safety precautions in this manual and the
manufacturer's instructions in the air tool manual, you
may now proceed to use your air-powered tool.
WARNING
than this air compressor is capable of providing. Check
the tool manual to avoid damage to the tool or risk of
7. Control the amount of air flow with the pressure
regulator knob. Turning the knob fully counterclockwise
will completely stop the flow of air.
NOTE: Always use the minimum amount of pressure
necessary for your application. Using a higher pressure
than needed will drain air from the tank more rapidly
8. To turn the air compressor off, press the power switch to
the OFF (O) position.
NOTE: When the compressor is in the ON (I) position,
the air compressor will automatically turn on when the
designated tank air pressure drops below the preset
pressure limit. It will also shut off again when the
desired pressure is reached.
WARNING
Never exceed the air tool's pressure rating as
recommended by the manufacturer. When using this
WARNING
position and the regulator pressure gauge reads zero
before changing air tools or disconnecting the hose from
the air outlet. Failure to do so could result in possible
9. When finished, always drain the tank and remove the
battery pack. Never leave the product operating or
connected to the battery pack.
DRAINING THE AIR TANK
See page 198.
To prevent tank corrosion and keep moisture out of the air
tank, the air tank of the compressor should be drained daily.
To drain the air tank:
1.
2.
3. Pull the ring on the pressure relief valve until the Tank
5. Turn the drain valve lever counterclockwise to drain the
moisture.
NOTE: Condensate is a polluting material and should
be disposed of in compliance with local regulations.
6. Turn the drain valve lever clockwise to close the drain
valve.

RESET BUTTON

When current into the air compressor motor exceeds the
To reset the air compressor:
1.
2. Turn off the product.
3. Wait three minutes for the motor to cool.
Press the reset button.
5. Connect the battery pack to the product.
6. Turn on the product.
CHANGING A COUPLER
See pages 199.
1.
2.
3. Pull the ring on the pressure relief valve until the Tank
5. Using a wrench, loosen and remove the coupler by
turning counterclockwise.
6. Using a wrench, install a new coupler and tighten in a
clockwise direction.

TRANSPORTATION AND STORAGE

See pages 200-201.
1.
2.
3.
air by pulling the pressure relief valve.
Drain water from the tank as instructed in "Draining the
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
English | 5