Switching On/Off; Loading/Unloading The Product - MBM GC477/SC Bedienungsanleitung

5. 3.
INSTRUCTIONS FOR USE

Switching On/Off

The appliance must be switched on after having filled
the cooking compartment with water. Do not switch it
on when the cooking compartment is empty.
When lighting for the first time, wait for the possible
formation of air inside the gas circuit to fully escape
from the duct.
Having successfully performed the water filling operations,
proceed with the "Switch On/Off" procedure as follows:
• Turn the knob and press it in the piezoelectric position.
Simultaneously press the piezoelectric button several times to
generate the spark which ignites the pilot light (Fig. 3A).
• Release the knob after about 20" and check to make sure the
pilot light remains lit. The pilot light can be seen through the
hole on the panel.
• When the pilot light has been lit, turn the knob to the desired
position (Fig.3B).
• Turn the knob to "Zero" (Fig. 3C) to switch the appliance off
at the end of the work cycle.

Loading/Unloading the product

After having switched the appliance on and the water begins to
boil, load the product into the container and place it in the cooking
compartment (Fig. 4).
We recommend a ratio of: 10l of water for 1kg of pasta.
Maintain a constant water level in the cooking
compartment. As needed, act on the water filling
knob (See Filling Water).
Some models are provided with a knob which
releases water at a reduced flow allowing constant
top up of water in the cooking compartment while
operating.
When cooking is over, remove the container from the cooking
compartment (Fig. 5) and put it in a place prepared beforehand.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 11 - - 11 - 11 11
A
A
B
C
3
Fig.
4
Fig.
Fig.
5