Warnings - Assembly Text Instructions - Maintenance - Extremis Sticks Handbuch

Warnings – Assembly text instructions – Maintenance
English
WARNINGS
General
• Do not use any sharp tools to open the
packaging.
• We strongly advise against using power tools.
• Tripping hazard, mind your step.
• Not grafitti proof.
• To avoid danger of suffocation, keep plastic bags
away from babies and children.
• Colours can differ over years and from batch to
batch.
Product
• Anchoring the product has to be done by
qualified people.
• For anchoring: use suitable bolts or screws from
a specialized store depending on the material
your terrace is made of.
• We consequently recommend that you thoroughly
dust or rinse the rods before inserting them into
the bases to reduce these fibres to a minimum.
• Do not touch the fibre glass rods with your bare
hands. Always use gloves to assemble Sticks.
During the production process tiny glass fibres
may come loose and could stick on the rods.
In case of skin contact they may cause slight
irritation. We consequently recommend that you
thoroughly dust or rinse the rods beofre inserting
them into the bases to reduce these fibres to a
minimum.
• Do not allow anyone to use the rods for playing or
jousting. This may cause injuries.
• Because of the specific characteristics of the
production process of fibre glass, colours can
only be reproduced approximatively and colour
differences may occur. This is the case for both
standard colours as for colours upon request.
• Rubberwood bases are not suitable for outdoor
use.
• When using the Sticks high up or in windy places,
we advise you to attach the bases to the ground.
In places where this is not possible, we offer a
weighted base.
• Due to their more limited wind resistance, we
advise you most strongly not to use the 50 x 25
cm bases outdoors.
• The rubberwood bases are not suitable for
outdoor use.
• Make sure the electrical modules (bases with LED
18
lighting, cables, adapters and switches) never
end up in a puddle.
Fibreglass
• Stains should be removed immediately with a
clean, soft cloth, particularly in case of dark-
coloured liquids sush as wine, ink, coffee, coke,
oil or bird droppings. If left to dry, these liquids
may cause permanent damage!
• Avoid using aggressive and abrasive products.
• The white hue can change to some extent when
exposed to UV.
• With darker colors, the ends may look paler
because of the white glass fibres.
• Color variations are possible, and even likely.
This is intrinsic to this production technique. It
contributes to the natural effect.
Rubber
• Rubber can cause stains on delicate floor,
therefore, we advise to use the plastic feet.
• Rubber can cause stains on carpets, therefore,
we advise to use only the wooden bases on
carpets.
• Rubber can fill a room with a light smell in the
first days after installation. This smell will fade
over time.
Led
• This product meets the requirements of European
Directives. 2006/95/CE and 2004/108/CE.
• 100-240V ~ 50/60Hz
• IP65
• The supplied plug is a Europlug (Type E). I n
countries where this plug is not used, pleaes
provide a suitable plug yourself.
ASSEMBLY INSTRUCTIONS
Sticks - p6
1. Assemble the feet using the screws provided.
a. Use the outer holes if you plan to use the base
outdoors, for greater stability.
b. Use the inner holes if you would prefer the feet
not to show too much.
2. Now insert the rods in the base.
With Led - p7
1. Begin by placing all the bases in (approximately)