Troubleshooting - Napoleon PRO825-3 Bedienungsanleitung

Troubleshooting

problem
Low heat / Low flame
when valve turned to high.
Excessive flare-ups/uneven
heat.
Burners burn with yellow
flame, accompanied by the
smell of gas.
rear and Side burners will
not light with the igniter,
but will light with a match.
main burner will not light
with the igniter, but will
light with a match.
Humming regulator.
Burners will not cross light
each other.
"Paint" appears to be
peeling inside lid or hood.
Burner output on "high"
setting is too low.
(rumbling noise and
fluttering blue flame at
burner surface.)
N415-0537CE-GB-DE SEptEmBEr 11.19
possible Causes
For propane - improper lighting
procedure.
For natural gas - undersized
supply line.
For both gases - improper
preheating.
Sear plates installed incorrectly.
Improper preheating.
Excessive grease and ash build
on sear plates and in drip pan.
possible spider web or other
debris in burner.
Dead battery / or installed
incorrectly.
Loose electrode wire or switch
terminal wires
Jet-fire outlet is dirty or
clogged.
Normal occurrence on hot days. This is not a defect. It is caused by internal vibrations in the
Dirty or corroded cross light
brackets.
Grease build-up on inside
surfaces.
Lack of gas.
Supply hose is pinched.
Dirty or clogged orifice.
Spider webs or other matter in
venturi tube.
Solution
Ensure lighting procedure is followed carefully. All gas
grill valves must be in the off position when the tank valve
is turned on. turn tank on slowly to allow pressure to
equalize. See lighting instructions.
Pipe must be sized according to installation code.
preheat grill with both main burners on high for 10 to 15
minutes.
See assembly instructions.
preheat grill with main burners on high for 10 to 15
minutes.
Clean sear plates and drip pan regularly. Do not line pan
with aluminum foil. Refer to cleaning instructions.
thoroughly clean burner by removing. See general
maintenance instructions.
Replace with heavy duty premium battery.
Check that electrode wire is firmly pushed onto the
terminal on the back of the igniter. Check that the lead
wires from the module to the ignition switch (if equipped)
are firmly pushed onto their respective terminals.
Clean jet-fire outlet with a soft bristle brush.
regulator and does not affect the performance or safety of
the gas grill. Humming regulators will not be replaced.
Clean or replace as required.
This is not a defect. The finish on the lid and hood is
porcelain, and will not peel. the peeling is caused by
hardened grease, which dries into paint-like shards, that
flake off. Regular cleaning will prevent this. See cleaning
instructions.
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.
17
EN
www.napoleon.com