English - Ruggear Rg650 Handbuch

ENGLISH

1. APPEARANCE DIAGRAM
1_SIM Card Tray: Insert SIM Card and Micro SD Card. See 9.1 for
more details.
2_Custom Button: Specified application/switch shortcut key, which
needs to be set via the system's "Custom Button" before being
used. See 10. for more details.
3_Earphone Jack: Connect 3.5mm earphones
4_Receiver
5_Front Camera
6_Microphone
7_USB Port: Micro USB port, used for mobile phone charging and
data transmission.
8_Increase and decrease the volume: Adjust the volume.
9_Power Button: Long press to turn on/off the device's power.
Short press to turn on/off standby mode.
10_Rear Camera
11_Flashlight
12_Speakers
2. INTRODUCTION
This document contains information and safety regulations which are to
be observed without fail for safe operation of the device RG650 under the
described conditions. Non-observance of this information and instructions
can have serious consequences and / or may violate regulations.
Please read the manual and these safety instructions before using the
device. In case of any doubt, the English version shall apply.
The current EU-declaration of conformity, certificates, safety instructions
and manuals can be found at www.RugGear.com, or requested from
Power Idea Technology (Shenzhen) Co., Ltd. .
3. RESERVATION
The content of this document is presented as it currently exists. Power
Idea Technology (Shenzhen) Co., Ltd. Does not provide any explicit or
tacit guarantee for the accuracy or completeness of the content of this
document, including, but not restricted to, the tacit guarantee of market
suitability or fitness for a specific purpose unless applicable laws or court
decisions make liability mandatory.
Power Idea Technology (Shenzhen) Co., Ltd. reserves the right to make
changes to this document or to withdraw it any time without prior notice.
Changes, errors and misprints may not be used as a basis for any claim for
damages. All rights reserved.
Power Idea Technology (Shenzhen) Co., Ltd. cannot be held responsible
for any data or other loss and direct or indirect damages caused by any
improper use of this device.
4. EU-DECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end
of this manual.
5. FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been
compromised, it must be withdrawn from use immediately.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if, for example:
• Malfunctions occur.
• The housing of the device shows damage.
• The device has been exposed to excessive loads.
• The device has been stored improperly
• Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is
suspected be sent back to Power Idea Technology (Shenzhen) Co., Ltd.
EN
4