Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page 9 of 24
If reusing the original indicators
•
If using the original indicators, please fit to the new licence plate bracket (item 1) as shown in picture
27 ( and then repeat for the opposite indicator).
•
Cut and fit the rubber U channel (item 18) to the cover/sealing bracket (item 3) as shown in picture 20.
•
Fit the rubber wiring grommet (item 4) to the sealing bracket as shown in picture 21.
•
Fit the sealing bracket assembly to the support bracket (item 2) using two of the M5 button head bolts
(item 21) with washers (item 22) as shown in picture 22.
•
Fit this assembly to the main licence plate bracket (item 1) as shown in picture 23 using the remaining
M5 button head bolt with washer (items 21 and 22).
•
Feed the indicator wiring through the nut/wire cover (item 15) as shown in pictures 24 and 25 (it helps
if a small amount of liquid detergent is used) and position the nut cover over the nut.
•
Fit one length of heat-shrink (item 19) to each the wires of the indicators so it goes over the tail of the
nut/wire covers (as shown in picture 25) and carefully warm to shrink heat-shrink to fit.
•
Repeat the above for the opposite indicator.
•
Feed all the wiring through the wiring grommet as shown in picture 26.
•
Offer the entire assembly up to the motorcycle and secure in position using the longer M6 bolts (item
11) and the washer type spacers (item 12) as shown in pictures 28 and 29 (do not fully tighten at this
stage).
•
Secure the support bracket using the shorter M6 bolts (item 8) with washers (item 5) as shown in
picture 30 (do not fully tighten at this stage).
•
Connect the original indicator wiring plug sockets (please ensure they connected to the correct socket)
(if using R&G mini indicators please use the two connectors (item 6= the ones with two wires) to
connect to the main loom as shown in picture 26 (you may have to use a resistor to achieve the correct
flash rate (product code RGR0003). If the indicators fail to function, please swap the connectors over.
Please use the supplied cable ties and self-adhesive clips to tidy and secure the wiring.
•
Using the male bullet connectors supplied (item 7) fit to the new rear light wiring as shown below re-
attach the rear light wiring as shown below.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
Email:
info@rg-racing.com
LP0266
BULLET CONNECTORS
(ITEM 7)
www.rg-racing.com
Werbung
