Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page 10 of 24
•
Then connect the supplied connector (item 23) to the rear light as shown and detailed
CON0061 WIRES-----------------------REAR LIGHT WIRES
BROWN-------------------------------------BLACK=EARTH/RETURN
YELLOW-------------------------------------RED=BRAKE LIGHT
GREEN----------------------YELLOW=RUNNING/SIDE LIGHT AND
•
Connect the new wiring connector (item 23) to the rear light plug socket, it is a good idea to test
indicators and rear light operation at this stage, if any lights do not illuminate, switch the bullet
connectors around. Please use the supplied cable ties and self-adhesive clips to tidy and secure the
wiring.
•
Alternatively, you can cut and shut (or solder) the original plug socket from the original rear light
using the bullet connectors (item 7) as detailed below.
OEM WIRES------------------------R&G WIRES
GREEN------------------- YELLOW=RUNNING/SIDE LIGHT AND LICENCE
YELLOW---------------------- RED=BRAKE LIGHT
BROWN----------------------- BLACK=EARTH/RETURN
•
Take the OEM tail light with the connectors on, and cut the wires, about 4cm up from the connector.
Strip back the ends of the three wires and fit three
CON0004).
•
Connect three
Reconnect the rear light plug socket, it is a good idea to test indicators and rear light operation at this
stage, if any lights do not illuminate, switch the bullet connectors around. Please use the supplied cable
ties and self-adhesive clips to tidy and secure the wiring.
•
Refit the fuel cap surround as original.
•
Tighten all bolts when happy with the positioning.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
LICENCE PLATE ILLUMINATOR
Do not connect the white wire
•
Do not connect the white wire
male
bullet connectors to the new tail light wiring and connect as indicated above.
R&G Racing
Email:
info@rg-racing.com
PLATE ILLUMINATOR
bullet connectors supplied (item 6 –
female
www.rg-racing.com
LP0266
below.
Werbung
