Toaster; Kettle; Coffee Machine; Descaling The Kettle And Coffee Machine - gourmetmaxx Z 01475 MD-213 Gebrauchsanleitung

• Check the mains cables for damage at regular intervals.
• Wipe the outside of the devices with a clean, damp cloth.
• Keep the devices ready for use.

Toaster

• Regularly empty the crumb tray of the toaster:
1. Remove the crumb tray carefully.
2. Remove the crumbs. Wipe down the tray with a damp cloth if necessary or rinse
it with a mild detergent under running water.
3. Dry the tray thoroughly.
4. Reinsert the crumb tray.

Kettle

Coffee Machine

1. Remove the permanent fi lter from the device and dispose of the coffee dregs.
2. Also remove the fi lter holder and rinse both parts as well as the coffee pot with lid
with a mild detergent and warm water.
3. Allow the permanent fi lter and fi lter holder to dry completely before inserting them
into the device again.

Descaling the Kettle and Coffee Machine

You should regularly remove water limescale deposits with a descaling agent in accord-
ance with the water quality in your area and how often the device is used.
Follow the instructions provided with the descaling agent to descale the kettle.
To descale the coffee machine, proceed as follows:
1. Fill the water reservoir up to the max marking with water and descaling agent (to
fi nd out how many parts water to descaling agent you should use, please consult the
instructions for use of the descaling agent).
2. Place the coffee pot with the lid closed onto the hotplate.
3. Switch on the coffee machine. After a moment, water will automatically trickle
through.
4. Once a quantity equivalent to around one cup has run through, switch off the device.
5. Allow the mixture to take effect for 15 minutes and then repeat steps 3 to 5.
6. Switch on the machine and allow the machine to run until there is no longer any
water left in the water reservoir.
01475_DE-GB-FR-NL_A5_V2.indb 29 01475_DE-GB-FR-NL_A5_V2.indb 29
• Remove the limescale fi lter from the kettle regularly and
rinse it with a mild detergent under running water.
To remove the fi lter, press down the locking catch on its
upper edge and remove it from its holder.
To reinsert the fi lter, fi rst push its lower tip into the holder
on the inside of the pouring spout. Then press the fi lter
against the wall of the kettle until the locking catch engag-
es. For this to happen, the locking catch must be pressed
up slightly with a fi nger.
29
10.11.2014 16:09:21 10.11.2014 16:09:21