Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In-line-installation FL60S
The floodlight FL60S ... is factory-fitted with a 3-pin connector.
For through-wiring for service the connector RST double connection request.
Rated current device connector mounted: 10 A.
Internal operating electronics equipped with over-voltage protection, over current
protection.
Maintenance and Repair
Special Safety Regulations
Compliance with the maintenance and repair work described in this chapter
is part of the intended use of the floodlight.
Maintenance and repair work may only be carried out by trained and
qualified persons. This applies in particular for maintenance and repair
work on the electrical system.
Before maintenance and repair work (this also includes cleaning work),
completely disconnect the floodlight from the power supply and make sure
that no third party can restore the power supply.
After maintenance and repair work, immediately mount or close all safety
and protection facilities again.
Also read the notes in the Safety chapter before maintenance.
Cleaning
Special care measures are not necessary as a rule. The housing and lamp cover
should occasionally be cleaned with a damp cloth.
Do not use solvents or solvent-based cleaner to clean the lamp cover and
the black plastic ring !
Page 17 of 27
02.02.2016
7179761000/ Index 03 / DCN 21969
de
en
fr
tr
el
es
pt
da
nl
no
sv
pl
cs
hu
Werbung
Kapitel
Inhaltsverzeichnis
