Campingaz Texado Benutzung Und Wartung Seite 9

g) prior to use
Never use the barbecue until the instructions have been read
carefully and understood. Also, make sure that:
- there are no leaks
- the venturi tubes are not blocked (example: spider webs)
venturi tube
- that the ventilation openings in the gas receptacle housing
are not obstructed, if appropriate.
- that the drippings tray has been properly inserted in the
tray housing and that it has been pushed all the way back
until it will not go in any further.
- the hose does not touch any components which may get hot.
Check that the venturi tubes
(VT) cover the injectors (ij).
h) Lighting the barbecue burners
Read steps 1 to 6 before beginning with step 1.
1) Never light the barbecue with the lid closed, only with the
lid open.
2) Make sure the control knobs are in the OFF (l) position.
3) Open the gas cylinder valve.
4) Press one of the 2 control knobs and turn it to the full
flame ( ) position, then immediately press the igniter
button ( ) until you hear the click. repeat 3 or 4 times if
necessary until the burner is lit.
5) If the burner fails to light, turn the control knob to the
OFF position (l). Wait 5 minutes before repeating
the operation. If your device has an electronic lighting
function, hold the button down for a few seconds to obtain
successive sparks.
6) As soon as the burner is lit, the other burner automatically
lights when the second control knob is placed in the full
flame ( ) position without pushing the automatic igniter
button again.
VT
ij
Important:
If the burner fails to light after the 2nd attempt, turn the control
knob to the OFF position (l) and check that the burner oulets
and venturi tubes are not blocked.
venturi tube
i) Grill burner-manual lighting
If the automatic ignition should fail to operate, turn the control
knob to the OFF position (l) and wait 5 minutes.
Remove the cooking grids. Hold a lighted match in the
opening located on the burner, turn the knob corresponding
to the control panel to the full flow position (
cooking grids.
j) Turning off the grill burner
return the control knobs to the "off" position (l) and the valve
of the gas cylinder.
k) Lighting the side stove
The stove may operate independently or in conjunction with
the grill burner.
Lighting:
- Open the gas cylinder valve.
- Check that there is no gas leak between the gas cylinder
and the stove.
- Check the condition of the hose connecting the grill burner
to the stove. should it present cracks, call our after sales
service to have it replaced.
- Open the stove valve (toward the +) and press the lighter
button ( ) to activate electronic lighting. If necessary, hold
the button down for a few seconds to obtain successive
sparks. If lighting does not occur, hold a lighted match next
to the burner.
- Adjust the size of the flame to the dimensions of the
container you are using by opening the valve to various
extents. Do not use a container smaller than 10 cm or
larger than 26 cm.
l) Turning off the side stove
Close the stove valve (towards the -) and the valve of the gas
cylinder if the grill burner is not in use.
m) Replacing the gas cylinder
- Always work in a well ventilated area and never in the
presence of a flame, spark or heat source.
- Return the control knobs in the OFF position (l) then close
the cylinder valve.
- Remove the regulator, check that the sealing joint is in
good condition.
9
Outlet holes
). Replace the
(if applicable to your model)
(if applicable to your model)
GB