Bicker UPSI-2406DP1 Benutzerhandbuch Seite 5

UPSI-2406DP1 | UPSI-2406DP2 | UPSI-1208DP2
Product specific data
Shutdown detection
Reboot function
Load sensor
Timer function
Relay
Backup time UPSI-2406DP2
* Backup at 100 W only works, if Supercaps have SOC > 60 % or voltage >7.5 V
Nominal measurement at +25 °C
Backup time depends on battery capacitance, load and temperature.
At very high or low temperatures a reduction of backup time occurs.
Unless otherwise specified, the values apply to measurements at +25 ° C
Via load sensor
Reboot function and time can be configured by software
Configurable via UPSI HID-Battery-Parameter software
(download at www.bicker.de)
UPS shuts down after 15 sec, if connected load decreases below set
value and UPS is being in battery mode
Configurable via UPSI HID-Battery-Parameter software in steps of
single seconds (3600 sec max)
Dry contact on power fail
(Normal mode: open / Backup mode: closed)
Relay switching current max 0.5 A @ 125 V AC / 1 A @ 24 V DC
Nominal backup time vs. P
P [W]
out
out
*
5