General Description; Safety Instructions - FILL-RITE 400 Serie Betriebs- Und Sicherheitsanleitung

Dear Fill-Rite Customer,
Congratulations on your purchase of Fill-Rite’s new
Series 400 Diaphragm Pump. We at Fill-Rite have
built our worldwide reputation by designing the finest
and most reliable pumps available in today’s market.
Your new pump was designed with pride by some of
the best and most experienced fluid control experts
available. We use the most advanced technology
possible to give you a pump with the superiority you
deserve and the quality you’ve come to expect from
Fill-Rite products.
Sincerely,
George P. Jenkins
President
DANGER
Not for use with fluids that
have a flash point below 100°F
(37.8°C, ie: gasoline, alcohol).
Refer to NFPA 325M (Fire
Hazard Properties of Flam-
mable Liquids, Gases, and
Volatile
points of common liquids.
Static electricity buildup and
discharge could result in arc
and explosion.

SAFETY INSTRUCTIONS

1. Use Teflon tape to seal all joints and avoid leakage
of fluids being pumped. Leaking of caustic and/or hazardous
fluids could result in severe injuries.
2. Never disassemble YOKE ASSEMBLY (see item 12).
This is under extreme pressure and injury could result.
3. Tank or barrel should be anchored to prevent tipping in
both the full and empty conditions.
4. The pump motor is equipped with thermal overload pro-
tection. If overheated, it will shut itself off without any
damage to the windings. Be sure to turn off the pump
power if this occurs. As the motor cools, it will start without
warning if power is on.
Electrical wiring should be
done by a licensed electrician
in accordance with approved
electrical codes. Pump
should be properly grounded
and a rigid conduit should be
used when installing electri-
cal wiring. Improper use or in-
stallation of this product can
cause serious bodily injury or
death.
DANGER
Solids) for flash
WARNING
This product should not be used for fluid transfer into aircraft.
This product is not suited for use with fluids for human
consumption.

GENERAL DESCRIPTION

The Fill-Rite Series 400 is a double action diaphragm pump,
using a patented, spring-driven, positive displacement
mechanism. The flow rate at with low viscosity material is up
to 13 GPM/49 LPM. The ultimate in chemical handling
capability is provided with stainless steel, polypropylene,
polyester and fluorocarbon wetted parts.
Fill-Rite 400 Series motors’ safety is proven by their listing with:
Underwriters Laboratories Inc., a nationally
recognized independent organization for
product testing to ensure public safety. Also
5
recognized in Canada.
NOTE: 230 VAC models are not UL listed.
Complies with applicable European standards.
•1" polypropylene ball valve/nozzle
•Buna-N or EPDM hose
•Telescoping steel suction tube
•807 mechanical (for viscosities up to diesel fuel) or 820
electronic digital meter (for thin or thick viscosities)
•2" NPT or 2" buttress inlet bung adapter
•1" FNPT straight and 90
•Wraparound tubular mounting frame
•Wall/tank mounting bracket
2
SAFETY
OPTIONS
inlet/outlet fittings available
o