Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - STG-BEIKIRCH TRZ 2A Technische Information Und Bedienungsanleitung

Rwa treppenraumzentrale
Inhaltsverzeichnis

Werbung

Störungshilfe
Störmeldung - Beep-Code - Tabelle
Bei der Störmeldung gibt die Pulsfolge einen Hinweis auf die
Störungsursache. Die akustische Störmeldung erfolgt nur bei
geschlossener Tür oder gedrücktem Türkontaktschalter.
Hinweis: Die gelb LED
RWA-Auslösung und die grüne LED grüne LED OK - Betrieb OK
leuchten dauerhaft während des Speicherchecks.
Wind-/oder Regenmeldung
Leuchtanzeige im Lüftungstaster LTA 25 und im Lüftungs-
bedienfeld der TRZ.
Auf-Anzeige
Leuchtanzeige im Lüftungstaster LTA 25 und im Lüftungs-
bedienfeld der TRZ. Die Anzeige leuchtet bei Lüftungsfunktion
Stopp oder AUF.
Kapazitäten der Akkus nicht ausreichend für 72 h
Netzersatzbetrieb
Die Messung der Stromaufnahme zur Überprüfung der Akku-
kapazitäten muss im Standby-Betrieb erfolgen und darf keinesfalls
direkt nach einer Motoransteuerung erfolgen. Der Standby-Betrieb
wird automatisch nach 3 Min. nach Ausführung von RWA-Reset
oder 3 Min. nach Ausführung der letzten Lüftungsansteuerung
eingeleitet.
14
- Störung, die rote LED
-

Troubleshooting

Malfunction - beep code - chart
The pulse sequence gives information regarding the source of the
malfunction. The continuous acoustical signal rings out only if the
door contact switch is pressed.
Note: The yellow LED
SHE activation and the green LED
permanently during the memory checks.
Wind-/or rain signal
Indicator lamp in the ventilation switch LTA 25 and in the ventilation
operation interface of the TRZ.
Open display
Indicator lamp in the ventilation switch LTA 25 and in the
ventilation operation interface of the TRZ. The indicator lamp
indicates at ventilation function stop or Open.
Capacitance of storage batteries is inadequately for 72 h
network compensational operation
The measurement of the current draw for testing the capacitance of
the storage batteries has to be done in standby mode. It may not
happen directly after a motor activation. The standby mode starts
automatically after approx. 3 min. when SHE reset is activated or
after the last ventilation operation.
- malfunction, the red LED
OK
- operating OK lits up

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis