Philips S8870 Bedienungsanleitung Seite 15

2
1
Using the click-on beard styler attachment without
comb
The length settings on the beard styler attachment
correspond to the remaining hair length after
cutting and range from 1 to 5mm (3/64 - 3/16in).
1 Attach the attachment to the appliance ('click').
Slide the comb straight into the guiding grooves
on both sides of the beard styler ('click').
2 Press the length selector and then push it to
the left or right to select the desired hair length
setting.
3 Switch on the appliance.
4 Move the appliance upwards while you exert
gentle pressure. Make sure the front of the
comb is in full contact with the skin.
5 Clean the attachment after use.
You can use the beard styler attachment without
the comb to contour your beard, moustache,
sideburns or neckline to a length of 0.5mm (1/32
in).
1 Pull the comb off the beard styler.
Note: Grab the comb in the center to pull it off
the beard styler. Do not pull at the sides of the
comb.
2 Switch on the appliance.
15
English