Mounting; Battery; Charging; Operation - Texas Equipment Razor 3300Li Bedienungsanleitung

Mounting

Unpacking
Remove the mower from the box by pulling the machine
out.
Warning: Ensure that the cable is not pinched.
Handlebar: Illustration 3a+3b
1. Attach the lower handlebar (5) on the lawn mower
and fix it with the quick fix knops (4) in both sides.
Do not overtighten the knops!
2. Attach the upper handlebar (3) on the lower
handlebar. Fasten with the quick fix knops (4) in
both sides.
3. Customize the cable and secure with cable clamp
Assembly the grass collector: Illustration 4
1. Click the frame to the grass collector.
Mounting the grass collector: Illustration 9
2. Attach the grass collector behind the lawn mower
under the rear deflector guard.
Mulching plug: Illustration 10
1. Insert the mulching plug (13), if you want to mow
with mulching functionality.
NB Don't use the grass collector
Important: Remember to remove the mulching plug,
when using the grass collector.

Battery

Warning: Do not try to dissassemble, short circuit or
put it to extreme heat or fire, as it can cause serious
inquiry and permanent damage to the battery!

Charging

Only use the original charger with art. no. 443548
(standard charger).
Before the battery is being used the first time, it is
recommended to full charge it first.
Note: The battery does not have any power indicator.
Important
To protect the battery from total discharge, the
machine will stop, when the battery is nearly empty.
The machine must not be started up again after
automatic shutdown, as it can damage the battery.
The battery must be recharges before the work can
continue.
Charging
Only use the original charger, which is included
with the product and do not try to charge other type
of batteries in the charger, other than the original
battery with art. no. 443547 (3.0Ah).
Keep the charger in a dry and warm environment
(10-25 degrees C) and only use it indoor. It should
be connected to a normal 230V AC socket.
Before the battery is being used the first time, it is
recommended to charge it fully.
The surface of the battery can become warm
during charging. This is normal.
Do not cover battery or charger during charging.
Allow free ventilation of air.
Illustration 6:
Insert the battery (10) into the slots of the charger (11)
and slide it into place until it lockes.
There are 2 lights on the charger indicating the status
and state of charge of the battery:
•
Constant green light: The charger is ready for
use, but no battery is connected
•
Constant red light: Battery is charging
•
Constant green light: Battery is fully charged
and should be removed from charger.
The charger will stop, when the battery is full.
However, it is not recommended to leave the battery
in charger for more than 24 hours.
It is recommended to drain the battery 80% and fully
charge it whenever possible, as it can increase the
health of the battery. But partial charge will not
damage the battery.
To remove the battery from the charger, simply pull
the battery out.
During winter storage, the battery should be partly
charged and kept dry and warm at 10-15 degrees C.
Make sure to keep ventilation holes clean and free
from dirt.
A full charge of battery takes around 150 min (3.0Ah
battery).
The battery cells will go to sleep-mode if ont used
for long time and must be activated again t oreach
full capacity. The battery will reach its full power
after 5 full recharge cycles. Therefore, you might
experience that for the first few times uses, the
battery's operating time is a few minutes less than
when it reaches its full power/capacity. This is
also the case after long times winter storage.

Operation

Safety key
The motor unit has a safety key, which is placed under
the battery cover. If the safety key is removed, the
power is disconnected, and it cannot start. See
illustration 9
It is always recommended to remove the safety key:
•
When the lawn mower is left unattended (to
prevent uninteded start, e.g. by minors)
•
Before clearning and maintenance
•
Before remove grass blockings
Remove the safety key, by pulling it out.
Insert the safety key to start the motor.
Place the key in the correct way!
Cutting height adjustment:
The mower has 5 different heights. The cutting height
ranges from 25 mm to 75 mm
12