Deleting Of The Limit Positions; Add An Emitter (Copy From Emitter A To Emitter B); Add A 2Nd Emitter On The Motor's Head; Delete Emitter B - heicko JSS25 Einbau- Und Bedienungsanleitung

3.7 Deleting of the limit positions

• When using the function, the blind can be in any position.
• This function deletes both limit positions.
x1
P2
Press P2 for Press „Down"
1 second for 1 second

3.8 Add an emitter (Copy from emitter A to emitter B)

x1
P2
A
Press P2 for
1 second

3.9 Add a 2nd emitter on the motor's head

This function is only possible if the limit positions have been set with emitter A.
x1
Press P1 for
2 seconds
3.10 Delete emitter B whilst emitter A remains active
x1
P2
A
Press P2 for
1 second

3.11 Delete emitter

• This function clears the connections from all emitters to the motor.
x1
P2
Press P2 for Press „Stop"
1 second
for 1 second

3.12 Enable / Disable step function

x1
P2
Press P2 for
Press „Up"
1 second
for 1 second
x1
P2
Press P2 for
1 second
x1
P2 P2
A
Press P2 for Press P2 for
1 second 1 second
B
+
B
Press „Up" and „Down"
simultaneously for
1 second
x1
P2 P2
A
Press P2 for
1 second
x1
P2
Press P2 for
1 second
x1
Press „Down"
for 1 second
x1
x1
B
x1
Note! - This function is not available when using the
controls HD05B, HD15BT, HR120033WA, HR120038G2,
HR1200-SUN-G2 and HR1300-WIND-G2!
x1
B
Press P2 for
1 second
x1
x1
Press either the "Up" or "Down" button for a short
movement (release within 2 seconds), press one of the
buttons for more than 2 seconds and the motor will start to
-13-
run continuously.