Change Of Rotation Direction; Adjustment Of The Limit Positions; Setup / Delete Intermediate Stop Function - heicko JSS25 Einbau- Und Bedienungsanleitung

3.4 Change of rotation direction

x2
Press P1 for
6 seconds

3.5 Adjustment of the limit positions

Important! - Please note
• For adjusting the limit positions the motor needs to be connected to an emitter.
• Both limit positions must be set as described (coherently, in one operation).
3.5.1 Limit setting mode
x1
P2
Press P2 for
1 second
3.5.2 Setting of the upper and lower limit position of motor type ERJSSDC06-34
Move to your
Press „Up"
for 1 second desired position
If you are in the limit setting mode and no command is given within 2 minutes, the motor
will automatically exit the mode.
The hanging can be moved to the previously set limit position by pressing the P1 multi-
function button. Pressing it again will stop the motor.
3.5.3 Correcting existing limit positions
To change the existing limit position, the hanging must be at the respective limit position.
x1
+
Press „Up"
and „Down"
simultaneously
for 5 seconds

3.6 Setup / Delete intermediate stop function

Important! - To set the intermediate stop function, the limit positions must be already set.
Move to your desired Press „Stop"
position for 1 second
x1
Press „Up" Press P2 for
for 1 second
Press „Stop"
for 1 second
or
Adjustment of the limit positions
press for at least 2 seconds for
a continuous movement
P2
Press P2 for
1 second
x1
P2
1 second
Press „Stop"
for 5 seconds
Press „Stop"
for 5 seconds
x1 x1
Press „Stop"
for 1 second
-12-
x1
Move to your desired
Press „Down"
for 1 second
x1
Press „Stop"
for 5 seconds
x1 Note! - This function is not
available when using the
controls HD05B, HD15BT,
HR120033WA, HR120038G2,
HR1200-SUN-G2 and
HR1300-WIND-G2!
x1
To get to the intermediate
position please press the
„Stop" button for 2 seconds.
Press „Stop"
for 1 second
position
Press „Stop"
for 1 second