Assembly Information; Charging Behavior; Radio Operation Of The Erjssdc06-34 Motors; Connecting The Motor To The Emitter - heicko JSS25 Einbau- Und Bedienungsanleitung

2. Assembly information

Important!
• Check the package contents and compare it with the information on the scope of delivery
• All assembly work related to the motor and the hanging is assumed to be carried out in a professional manner.
• Before installing the venetian blind, check the local conditions and make sure that the conditions are met.
Otherwise, it cannot be ruled out that the venetian blind will be work properly. If this is not the case, there is no
malfunction of the motor, but an unfulfilled installation condition.
Motor
Assembly of the clipping fix brackets:
• Mount the two clipping fix brackets on the back of your venetian blind on the pre-drilled holes.
• Hang the venetian blind on your window or door wing and fix the clipping fix brackets in the required position.
• Fasten the cover caps on the clipping fix brackets.
Assembly of the ceiling brackets
• Mount the two ceiling brackets on your ceiling using suitable fastening material.
• Push the venetian blind into the brackets and let them snap into place (spring mechanism).
3. Rechargeable tubular motor type Typ ERJSSDC06-34
3.1 Charging behaviour
The battery must be fully charged before first use. To conserve the battery capacity the motor is switched to a sleep mode. Initial
connection to the charger will cancel this sleep mode.
LED status display on charger: During charging = red glowing, fully charged = green glowing
3.2 Radio operation of ERJSSDC06-34 Motors
The Operation of these motors is only possible with emitters with radio code G2. Information on which emitters have radio code G2 is available at
www.heicko.de or www.heicko-bewegt.de.
Illustrations may differ from
the items and are only for
the purpose of illustration.
Supply line
Antenna

3.3 Connecting the motor to the emitter

x1
Press P1 for
2 seconds
Clipping fix
brackets
Multi-function button P1
(recessed button)
x1
P2
Press P2 for
1 second
Ceilling
brackets
x1
P2
Press P2 for
1 second
-11-
Illustration without
covering cap
Illustrations may differ
from the items and are
only for the purpose of
illustration.
Up
Stop
Down
Setup
button P2
Button cell
x1
Press „Up" for
1 second
P2 P2
3V
M