Clock And Timers - THOMSON MIC250IDABBT Bedienungsanleitung

Battery power
• Be sure that the batteries are inserted correctly to avoid damage to the appliance. Always remove
the batteries when appliance will not be used for a long period of time, as this will cause leakage to
the batteries and subsequently damage to your set.
• Use batteries of the same type. Never use different types of batteries together.
• Do not throw the battery into the fire, or exposed to sunshine or the like.
• If the liquid contained in the batteries comes in contact with eyes or skin, wash the area immediately
and carefully with clear water and consult a doctor.
Unit power supply (mains 230V/50Hz)
Connect the power cable plug to the (230V) wall outlet.
Warning:
• Before using the unit, check that the local mains supply is compatible with the unit 230V (50Hz).
• Do not plug or unplug the power cable when your hands are wet.
• When planning not to use this unit for long periods of time (i.e. vacation etc.), disconnect the plug
from the wall outlet.
• When disconnecting the power cord from the wall outlet, grasp the plug; do not pull the cord in order
to avoid shock risks caused by the damaged cable.
Operation
Press the POWER button to turn the unit ON/OFF.
Adjusting the volume
Rotate the Volume knob clockwise to increase the volume.
Rotate the Volume knob anti-clockwise to decrease the volume.
Check the display, which will confirm the volume setting.
Mute Function
Press the MUTE button on the remote control. The volume is muted and "Volume Muted" will appear
on the LCD display. Press this button again to cancel the mute function.

Clock and Timers

Setting the clock and date
After the unit is plugged into a mains supply or following a mains power failure, the display will show the
current time and date on the LCD display. The unit should be in standby mode to set the current clock.
1. Press the CLOCK button; "Time setup" is displayed. Press ENTER to confirm; "time wizard
interval" is displayed.
2. Press /
will blink.
3. Press /
blink.
4. Press /
blink.
5. Press / to set the year; press ENTER to confirm. The month digits on the display will blink.
6. Press /
7. Press /
Setting the alarm
Note: Check that the radio has the correct time and date before you set an alarm.
This unit may be used as an alarm clock. The Bluetooth device, CD/USB device or DAB/FM radio is
activated to play at a preset time.
1. Press the POWER button to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press the ALARM button in shutdown state; press ALARM twice to set Alarm 2.
4. "Alarm 1 (or 2) Setup" is displayed. Press the ENTER button to select.
to select "24H" or "12H". Press ENTER to confirm. The hour digits on the display
to set the hour; press ENTER to confirm. The minutes digits on the display will
to set the minutes; press ENTER to confirm. The year digits on the display will
to set the month; press ENTER to confirm. The day digits on the display will blink.
to set the day; press ENTER to confirm. Press
- EN 6 -
/ to select "YES/NO"