Troubleshooting; Cleaning - Silvercrest RC DP3 4001-A FR 3726 Bedienungs- Und Sicherheitshinweise

The LED operating status display
will go out.
3. Confirm the ALL ON / OFF button
to switch all remote-controlled
3
sockets simultaneously.

Troubleshooting

Q
If the remote control does not
work, please check the follow-
ing points:
Prob- The operating indica-
lem tor
1
control device illumi-
nates but there is no
reaction
Rem- · Check if the battery still
has sufficient Ampere. If
edy
necessary, install a new
battery.
Prob-
No indicator light
lem
on remote control
when pressing "ON"
or "OFF"
Rem- · Check if the battery is
inserted correctly.
edy
· Check if the battery has
good contact, if neces-
sary press down.
34 GB
5
on the remote
1
Prob- No reaction from
lem consumer
Rem- · Check that the appliance
is switched on.
edy
· Assign a new code to
the wireless socket (see
"Setting up the wireless
socket").
· Check - by walking closer
to it - that the range is
correct for the desired
location.
Prob- Range is too small
lem
Rem- · For large ranges, ensure
edy that as few walls and as
little furniture as possible
are in the way of the
remote control and the
radio-controlled socket.
· If the range is too small
at times, the reason could
be a remote control which
works on a similar fre-
quency. Whenever this re-
mote control is active, the
range declines (e.g. wire-
less headphones, ra-
dio-controlled movement
alarms, radio gongs etc.).

Cleaning

Q
Before cleaning, always disconnect
the radio-controlled socket from the
wall socket and remove all power
plugs from the device.