Scansonic P3600 Bedienungsanleitung Seite 8

Installation
- Read the manual thoroughly before operating the device!
- Choose a suitable location for the device. Suitable locations are dry,
even and anti-slip surfaces on which you may operate the device easily.
- Make sure there is proper ventilation for the device!
- Remove, if necessary, the protection sheet from the display.
Power supply (Adaptor)
- Insert the grid plug into a properly installed AC socket. Connect the
device with the plug connector by inserting its plug into the DC 5V
jack of the device.
- Make sure the grid voltage corresponds to the figures on the rating
plate.
CAUTION:
- Only use the supplied power adaptor for this device.
Do not use for other devices.
- Only use the original AC adapter. This adapter has been specially
designed for the built-in battery in order to gradually charge the battery.
Any other adapter can shorten the battery life or can damage it or the
device.
NOTE:
Disconnect from mains power supply during longer periods of non-use.
Charging the battery
Before you can operate the device with the battery, you need to charge it
first.
1. Turn off the device by setting the ON/OFF switch (14) to the "OFF"
position.
2. Connect the device to a wall socket with the power adaptor. The battery
charging indicator (12) lights up Yellow and the battery is being charged.
Once the battery has been charged completely, the charging indicator
turns Green.
CAUTION:
Never leave the device unattended during the charging process.
8
P3600
FM DAB+