ASSEMBLY INStRUCtIoNS AND INStRUCtIoNS FoR USE
1. PARt LISt (fig. 1)
. SEttING UP (fig. )
Set the baby walker up by grasping the upper part of the table and pull it up to the highest
position.
3. WHEELS (fig. 3)
Place the baby walker upside down on a flat floor, press the wheels with the plastic pins into the
mounts until they click in. Make sure all the wheels are firmly fixed in place.
4. SEAt AttACHMENt (fig. 4a, 4b)
to fasten the seat attachment, press the plastic pin into the corresponding seat unit holes (4a,
4b), and lock by pressing the pins downwards. Do check the seat is firmly in place before you
put your child into the baby walker.
5. ADjUSt tHE SEAt HEIGHt (fig. 5a, 5b)
5a. the adjustor is placed underneath the top tray of the baby walker. Squeeze the adjustor up
and slide the adjustor forward or backward to adjust the seat position. the height of the baby
walker could be adjusted to 3 positions. to close the baby walker, you can release the adjustor
all the way to the front.
5b. Pull and twist the button after you have adjusted the baby walker to the suitable height as a
security lock. to release the security lock, reverse the sequence before you do step 5a.
AttENtIoN: Do not adjust the position when the child is inside
the baby walker.
6. ASSEMBLY tHE toY PARt (fig. 6a-6b)
there are plastic locks on the top tray of the baby walker, which are used to fix the toy part.
Pull the plastic locks out and slot into the bottom of the toy part (6a), turn the locks at the
bottom of the top tray and fix the toy compartment firmly (6b).
Use only x 1.5V R6 batteries. Check polarity when inserting the batteries.
CAUtIoN
•
Non-rechargeable batteries are not to be recharged.
•
Rechargeable batteries are to be removed from the toy before being charged.
•
Rechargeable batteries are only to be charged under adult supervision.
•
Different type of batteries or new and used batteries are not to be mixed.
•
only batteries of the same or equivalent type as recommended are to be used.
•
Batteries are to be inserted with the correct polarity.
•
Exhausted batteries are to be removed from the toy.
•
the supply terminals are not to be short-circuited.
•
Electronic toy compartment should put onto the top tray anytime when the baby stays in the
baby walker.
•
Batteries should be removed from the toy compartment if the product is not going to be used in
a short while.
CARE AND MAINtENANCE
IN GENERAL
Please check the baby walker function on a regular basis. Make sure that the frame is stable,
the screws are tight. Check the cover occasionally, making sure that the stitching is still firm,
and inspect the quality of the plastic parts. Any broken or worn working parts should be replaced
immediately. Proceed in the same manner with components that are broken, torn, defect or worn-
out. Please use only original hauck replacement parts.
CLEANING tHE CoVERS
Remove the covers from the frame. Please read the instructions on the sewn-in label before
cleaning. to clean the cover gently, wipe it down evenly using only a damp cloth. As long as there
are no plastic, wood or metal parts on or in the cover, it can be machine-washed at 86°F (30°C) and
medium speed. the cover should be air-dried, but not exposed to excessive sunshine. Please do
not dry the cover in the drier, to avoid shrinking. Do not re-fit the covers until they are completely
dried.
CLEANING tHE FRAME
Use only mild soapy water or lukewarm water to clean the frame of your stroller. Plastic parts can
be cleaned with mild detergent cleaners.
GB
7