Getting Started - Velleman WIFIR1 Gebrauchsanleitung

WIFIR1
x Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
x Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
4. Overview
Refer to the illustrations on page 2 of this manual.
You can attach the repeater's plug horizontally or vertically so the
repeater fits into any space.
x Press and hold down [A] and pull the plug to detach it.
x Place the plug back in the socket in the desired position and turn
it until it snaps into place.
To reset the WIFIR1, press and hold the reset button for 10 seconds.
Note: the procedures in this manual are for the Windows
operating system. Installation is similar for other Windows versions.
For more information, refer to:
http://windows.microsoft.com/en-US/windows7/Add-a-device-or-
computer-to-a-network
http://windows.microsoft.com/en-US/windows7/Setting-up-a-
wireless-network
http://windows.microsoft.com/en-US/windows-vista/Setting-up-a-
wireless-network
5.

Getting Started

Wireless repeater mode: Wireless AP mode:
You need WiFi AP/Router internet You need broadband router
access. The WIFIR1 connects internet access. Connect the
wirelessly to your wireless router. WIFIR1 to your wireless router
You can configure the WIFIR1 by using an RJ45 cable.
connecting it to your pc using the See 6.c. for configuration.
V. 01 – 14/02/2012 4
®
7
©Velleman nv