Cleaning And Maintenance - Beurer Barbers Corner HR 6000 Gebrauchsanweisung

• If you want to use the length-adjustable
comb attachment, attach it to the device
as shown.
Here, slide the front part of the length-ad-
justable comb attachment onto the stain-
less steel razor blade and press the tabs
on the back of the length-adjustable
comb attachment onto the device until
you can hear and feel it click into place.
When selecting the trimming length with
the length-adjustable comb attachment,
we recommend you initially start with
the longest cutting length so that you
can slowly work your way to your de-
sired length. Turn the selection dial on
the length-adjustable comb attachment
to select the required trimming length.
The settings on the dial correspond to
hair length in millimetres.
• Press the ON/OFF switch
the device. The operating display begins
to light up.
• Guide the device slowly through the body
hair. Ensure that the stainless steel razor
blade sits as flat against the body as pos-
sible.
• Always only trim small areas.
• Cut the hair against the direction of
growth. If the hair grows in different di-
rections, use the device in multiple di-
rections.
• Press the ON/OFF switch
switch off the device after use. The op-
erating display turns off.

9. Cleaning and maintenance

Cleaning the device
WARNING
• Always pull the mains adapter out of the
socket before cleaning the device. Risk
of electric shock!
• Remove the length-adjustable comb at-
tachment before cleaning.
• Only clean the housing of the device with
a soft cloth dampened with warm water.
• Do not clean the device with highly flam-
mable liquids. Risk of fire!
to switch on
again to
32
• Do not clean the device in the dishwasher.
• Clean the stainless steel razor blade and
the length-adjustable comb attachment
after each use to prevent lots of hair get-
ting jammed inside, which could other-
wise impede flawless operation.
• Leave the length-adjustable comb attach-
ment to dry completely before you re-
attach it to the device.
• If you do not use the device for a long
period of time, place the protective cap
over the stainless steel razor blade and
store the device and the length-adjusta-
ble comb attachment in the storage bag
supplied.
Cleaning the stainless steel razor blade
After use, blow on the length-adjustable
comb attachment and the stainless steel
razor blade to remove any hair from them.
You can also carefully remove wet hair with
your fingers.
WARNING
When cleaning using your fingers, ensure
that you do not injure yourself on the sharp
edges of the stainless steel razor blade.
To clean the stainless steel razor blade par-
ticularly thoroughly, you can also rinse it
under running water. To do so, proceed as
follows:
1. Carefully grasp
the stainless
steel razor
blade from be-
low in the red
area using your
thumb and in-
dex finger. Pull
the stainless
steel razor blade up and off.
When removing the stainless steel razor
blade, ensure you do not injure yourself
on the sharp edges.
2. Hold the stainless steel razor blade un-
der running water so that the jet of wa-
ter runs through the stainless steel razor
blade from the inside out.
33