Chicco miinimo2 Gebrauchsanleitung Seite 13

5. To adjust the hood, pull and/or push it centrally (Fig. 5).
NG
The hood can be extended by opening the zip on the
first section (Fig. 5-5A). To remove the hood from the
ap. frame, carry out the procedure shown in point 4 in the
th. reverse order.
ust WARNING: Keep the hood out of reach of children when
it is not in use
HOW TO USE THE SAFETY HARNESS
This stroller has a five-point safety harness featuring two
shoulder straps, two adjustment holes, a waist strap and a
crotch strap with buckle.
6. WARNING: To use it with children from birth to approx.
6 months of age, use the shoulder straps by threading
them first through the two horizontal adjusting holes,
the waist straps must be inserted into the vertical holes
(Fig. 6). After laying the child in the stroller, fasten the
belts by threading first the two forks inside the shoulder
straps' slot and then introduce them inside the crotch
strap buckle (Fig. 6A); adjust the length of the straps, en-
ght suring that they adhere to the child's shoulders and body
correctly.
ep 7. To unfasten the waist belt, press and pull the lateral forks
ay (Fig. 7-7A).
WARNING: Always use the restraint systems. For the safety
all
an of your child use all five fixing points of the safety harness
belts.
Make sure to reassemble correctly the waist straps (e.g.
after washing ) and the crotch strap, threading them
through the holes located on the backrest and on the
seat. The harness must be re-adjusted.
HOW TO ADJUST THE BACKREST
he
me The backrest can be adjusted to 4 positions.
are 8. To lower the backrest, lift the adjusting handle located on
nd the rear of the backrest (Fig. 8).
9. To raise the backrest, simply lift it to the desired position
in (Fig. 9).
WARNING: The child's weight can make these operations
ed.
more difficult.
REAR BRAKES
be
ig. The rear wheels have linked brakes, which can be applied
el. simultaneously on both rear wheels by using one pedal
nto alone.
me 10. To operate the stroller' s brakes, press downwards the pedal
located at the centre of the rear wheels axle (Fig. 10).
he 11. To release the brakes, push upwards the pedal located
mly. at the centre of the rear wheels axle (Fig. 11).
FRONT SWIVEL WHEELS
et- 12. To make the wheels swivel, lift the lever found between
4), the two wheels (Fig. 12).
nd 13. To lock the wheels, raise the lever (Fig. 13).
WARNING: Both front swivel wheels must always be
as
he locked or unlocked at the same time.
of WARNING: The swivel wheels make the stroller easier to
he handle; it is recommended to use the wheels in fixed mode
cro on uneven ground to guarantee better stability (on gravel,
unpaved roads, etc.)
he
HOW TO ADJUST THE LEGREST
The stroller's legrest can be adjusted into 2 positions for
your child's improved comfort.
14. To adjust the legrest in the desired position, operate si-
multaneously the two side levers (Fig. 14). To raise the
legrest up from the down position, just pull it up.
CARRY-ALL BASKET
The storage basket is already installed.
15. In order to remove it, release the six snap buttons locat-
ed on the basket sides (3 per side) and extract the straps
from the holes located on the frame (Fig. 15).
RAIN COVER
16. To mount the rain cover, fully open the hood, wrap the
velcro around the stroller tubes in the positions shown
in figure 16; repeat this operation on the other side.
When you have finished using the rain cover, allow it to dry
properly if it is wet.
WARNING: The rain cover cannot be used on the stroller
without hood, as it may cause suffocation.
WARNING: When the rain cover is fitted on the stroller, nev-
er leave it exposed to direct sunlight with the child inside, as
the temperature will rise considerably.
FITTING AND REMOVING THE STROLLER LINING
17. to remove the lining from the frame, remove the hood
following the procedure shown in point 4 in the reverse
order. To remove the fabric part of the stroller, extract
the side flap from the 3 plastic pins located on the rear
side of the handle tube (Fig. 17) on both sides, then re-
move the two waist straps and the crotch strap form the
special holes located on the backrest and on the seat
(Fig. 17A-17B).
18. Release the fabric flap from the pin located under the
seat (Fig. 18) making sure to carry out the same opera-
tion also on the other side, then complete the operation
releasing the belt located under the seat (Fig. 18A). At
this point the fabric part is released from the frame and
can be extracted from the legrest (Fig. 18B). Unhook the
fabric from the side of the bumper bar supports (Fig.
18C) and remove. To complete the removal of the back-
rest fabric, slide the plastic component positioned on
the sides inwards and pull the fabric part upwards (Fig.
18D). The operation must be performed on both sides
of the backrest.
To reinstall the fabric part on the stroller, repeat the above
procedure in the reverse order, making sure to tension
again the belt located under the seat (Fig. 18A) at the end
of the procedure.
FOLDING THE STROLLER
WARNING: When opening the stroller, make sure that your
child or other children are at a safety distance.
WARNING: Make sure that during these operations the
moving parts of the stroller will not come into contact with
your child
before closing the stroller, make sure that the storage bas-
ket is empty and the canopy is closed.
19. To close the stroller, push switch A to the left and simulta-
neously press the button B (Fig. 19).
Rotate the handle forward until aligning it to the side tube
(19A), grasp the side tubes of the stroller (Fig. 19B) and press
them lightly to collapse the structure.
20. To complete the closure operation, press downwards
13