Filling The Tub - TECNOINOX CP35G7 Handbuch

Part 3
Check that the water drain valve "C" (fig.2) inside the appliance, is
closed, "horizontal".
Fill with water by turning knob "W" (fig.2).
Press and turn knob "A" (fig.4) from position "
pressed in.
At the same time press ignition button "B" (fig.4) repeatedly to light the
pilot light.
After the flame has lit, hold the knob down for roughly 10 seconds
(count to 20); so the thermocouple heats up and keeps the safety valve
open.
To light the main burner, turn the knob again until it reaches the desired
position.
Note: if the piezoelectric device cannot be used, you can light the flame
by hand using a match or a gas lighter.
MAKE SURE: the machine is off, the water is at room temperature and
you have connected a drain tray under the drain valve "OUT" (fig.1).
Slowly turn the knob of the valve 90° from the horizontal position "C"
(fig.2).
Turn the gas shut-off cock installed upstream off. Clean the appliance
with soapy water, rinse, dry carefully and apply a light layer of liquid
paraffin.
In most cases malfunctions are caused by dust and dirt in the operating
components.
Unauthorised persons should never attempt to repair the appliance, or carry out maintenance. Tampering with the appliance
voids the warranty!

Filling the tub

Turning the burner on and off
●
" to " " keeping it
Emptying the tub
What to do if the unit is not going to be used for a long time
Do not use the appliance without water.
Off
TURNING THE BURNER OFF:
Turn the knob from the position it is in to the "
TURNING THE APPLIANCE OFF:
Turn the knob to the "●" position.
Close the valve after you have drained the tub.
Malfunctions
In any case, if you suspect the presence of anomalies close the gas
shut-off cock and inform the authorised after-sales service.
GB / IE - 4
WARNING!
Flame on
Burner MAX
pilot light
" position.
WARNING!
Use
Burner min
5410.264.00