Parts And Functions - Canon K30274 Benutzerhandbuch

Parts and Functions

LK-62 contains a battery pack and two battery attachments. LK-61/LK-60 or iP100
with battery contains a battery pack and a battery attachment. See below for
details.
Battery Pack LB-60
This is a lithium-ion battery. To use the battery, load the battery pack in the
battery attachment.
Printer connector
Battery Attachment
The battery attachment is the case used to load the battery pack and
connect it to the printer.
* Certain models may not be available in some countries or regions.
For iP100 series
(1)
* This battery attachment is for iP100 series and
supplied with LK-62 and iP100 with battery.
For mini260/mini320
(1)
* This battery attachment is for mini260/mini320
and supplied with LK-62, LK-61 and LK-60.
(1) Charge lamp
The lamp stays on, turns off or flashes to indicate the battery charging
progress and battery condition. When an error occurs, the lamp flashes.
For the battery charging progress, see "Charging the Battery."
For the battery condition and errors, see "Troubleshooting."
Attaching the Battery to the Printer
When using the printer in locations where there is no power outlet (outdoors,
etc.), attach the battery (i.e. battery pack installed in the battery attachment)
to the printer. Before using the battery pack and battery attachment, read
"Safety Precautions" thoroughly.
1
Turn off the printer and disconnect the AC adapter and USB
cable from the printer.
2
Load the battery pack in the battery attachment.
Load the battery pack in the battery attachment with the printer
connector facing upward, and then push down on the battery pack until
it clicks.
* The design may differ depending on the printer you are using.
Important
If the printer connector of the battery pack is dirty, the printer may not
operate. Keep the printer connector clean. If it becomes dirty, wipe it
clean with a soft, dry cloth.
Printer connector
4