Charging The Battery - Canon K30274 Benutzerhandbuch

3
Unload the battery pack from the battery attachment.
Unlock the lever on the battery attachment as illustrated below, and
unload the battery pack from the battery attachment
Lever
* The design may differ depending on the printer you are using.
4
Attach the battery connector cover (s) to the printer.

Charging the Battery

To operate the printer from the battery, the battery pack must be charged
fully. Since the battery pack is not charged when it is purchased, charge it
following the procedure explained below.
To charge the battery, load the battery pack in the battery attachment, and
attach it to the printer. For procedures, see "Attaching the Battery to the
Printer."
Important
Do not connect the AC adapter to the printer before attaching the battery to the
printer. If you attach or remove the battery with the AC adapter connected,
charging may not start. In this case, disconnect the AC adapter from the printer
and then reconnect it.
1
.
2
Charge the battery pack at a place where the ambient temperature is between
5°C and 35°C/41°F and 95°F. If the temperature is outside this range,
charging of the battery pack may not progress or the performance may be
degraded. If the ambient temperature is low, the charging time may become
longer. If charging still takes a long time (about 5 to 6 hours) even though
printing is not activated while the battery is being charged, the ambient
temperature may not be between 5°C and 35°C/41°F and 95°F.
While the battery pack is being charged, the charge lamp flashes or turns off
to indicate the charging progress even if the printer is turned off.
You can use the printer while charging the battery. In this case, the charging
time becomes longer because charging is interrupted during printing. The
charge lamp flashes red.
Plug the power cord into the AC adapter, and then connect the
AC adapter to the printer.
iP100 series
Plug the power cord into a power outlet.
The charge lamp starts flashing red, and charging of the battery pack
starts. The charging progress is indicated by the charge lamp. When
the lamp turns off, charging of the battery pack is complete. See below.
Charge lamp
The lamp flashes red.
The lamp turns off.
Notes
mini260/mini320
* The design may differ
depending on the printer
you are using.
Progress
Insufficiently charged.
Fully charged.
7