Installation; Installing The Tap; Operation; Bringing Into Use - lidl 284570 Montage-, Bedienungs- Und Sicherheitshinweise

CAUTION! RISK OF DAMAGE TO
PROPERTY! Have the installation done by
experienced persons only. Leaks or escape
of water can lead to serious damage to
buildings or household fittings and furniture.
Check all connections for leaks carefully.
Ensure that all seals are correctly seated to
prevent leakage of water.
The spout can be swivelled to your desired
position. Make sure the spout is always
positioned within the area of the sink,
otherwise escape of water can lead to
serious flooding to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is
not too high.
Before installation, make yourself familiar
with all the existing services, e.g. water
connection and stopcocks.
Please read carefully through these operating
instructions before installing and using
the product. Keep all the safety advice
and instructions in a safe place for future
reference!
§ Installation
§ Installing the tap
Turn off the main water supply to prevent
serious leakage of water. Allow any
remaining water in the pipework to drain.
Install the tap as shown in Figs. A to E.
m
CAUTION! Do not bend the flexible hoses
or place them under tension. Otherwise
7
material damage could result.
The rubber hose
17a
you want to change to different colour
(see Figs. I to J).
6 GB/IE/NI
/ can be replaced if
17b
§ Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these steps
(see Fig. F):
Use the key to screw the mixer nozzle
18
off.
Open the main water supply and allow the
water to run for two minutes.
Then use the key
18
on again.
9
§ Operation
§ Bringing into use
Note: If the fitting has not been used for a long
period flush the pipes through thoroughly in order
to avoid stagnation and build-up of residues in
the drinking water supply.
Open the main water supply.
Lift the control lever
right or left in order to regulate the speed or
temperature of the water flow.
Press the changeover switch
spray jet.
Press the changeover switch
set to normal spray jet operation.
Check operation of the mixer. For this
purpose move the lever
positions. Please regularly check all
connections to ensure that they are tight.
Pull out the spray head to have freedom of
movement of the spray head when in use.
§ Setting the temperature
limiter
The cartridge in this unit has a temperature
16
limiter. This function is not activated in the
factory (neutral setting).
m
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
9
to screw the mixer nozzle
and swing it to the
10
to set the
8
once more to
8
in all possible
10