Glomex PANDORA V8000 Betriebs- Und Installationshandbuch Seite 52

PANDORA V8000 - URANIA 2 V9330
3. Connect the power supply cable (12 V) to a free
switch for the on-board electronic devices (min.
5A): connect the positive terminal to the red
cable and the negative terminal to the black
cable. The power supply line must have cables
with a minimum cross section of 2.5 mm
length up to 4 m, of 4 mm
Fig. 19
S
WARNING
Do not use power supply from secondary circuits.
This could jeopardize the operation of the
equipment.
NOTE: The polarity inversion on the power supply
blows the fuse to prevent any damage to the
antenna.
2
with a
2
for longer cables.
50
S
WARNING
Pay attention not to bend the coaxial cables at a
right angle; the bending angle must always be
higher than 120°.
Fig. 20
NOTE: Do not cut the connectors of the coaxial
cables (the operation would not be guaranteed any
more) and always use the supplied cables, even
with inappropriate dimensions (too long). Do not
use different cables, as it would jeopardize the
operation of the equipment.
4. Build in the control unit by using the GLOMEX
accessory (code 4.010.0008) by boring a hole
with a reciprocating saw and using the drill with
2.5 mm tip (use the cutting template in Fig. 22
for correct dimensions).
5. Connect the 1.5 m coaxial cable to the V9115
line amplifier. Connect the second 1.5 m cable
between the V9115 line amplifier and the LBN
IN socket of the satellite receiver (not included).
NOTE: Maximum wall thickness for mounting the
control unit: 20 mm.
www.glomex.it