Installing The Solid-State Drive (Half-Length); Removing The Solid-State Drive (Full-Length) - Dell Precision 5510 Bedienungsanleitung

3. Remove the screw that secures the solid-state drive assembly to the system board [1, 2].
4. Lift and slide the solid-state drive assembly from the system board [3].
5. Remove the screw that secures the solid-state drive to the solid-state drive bracket [1, 2, 3].
6. Lift the solid-state drive off the solid-state drive bracket.

Installing the Solid-State Drive (half-length)

1. Align the screw hole on the solid-state drive bracket with the screw hole on the solid-state drive.
2. Replace the screw that secures the solid-state drive to the solid-state drive bracket.
3. Align the notches on the solid-state drive assembly with the tabs in the solid-state drive slot.
4. Slide the solid-state drive assembly at an angle into the solid-state drive slot.
5. Press the other end of the solid-state drive down and replace the screw that secures the solid-state drive to the system board.
6. Install the:
a) battery
b) base cover
7. Follow the procedures in After Working Inside Your Computer.

Removing the Solid-State Drive (full-length)

1. Follow the procedures in
2. Remove the:
a) base cover
b) battery
Before Working Inside Your Computer
Entfernen und Einbauen von Komponenten 11