Maintenance And Cleaning; Cleaning The Sensors - Beko DV 8120 N Bedienungsanleitung

6 Maintenance and cleaning

Lint filter
Lint and fibres released from the laundry to the
air during the drying cycle are collected in the
"Lint Filter".
C
NOTE
• Such fibre and lint are generally formed
during wearing and washing.
• Always clean the filter after each drying
process.
• You can clean the filter and filter area by
vacuum cleaner.
Figure 1
Figure 2
To clean the filter:
1.Take out the cover.
2.a) If the product's lint filter can be opened
as shown in Figure 1, remove the filter by
pulling it up and open the filter.
2.b) If the product's lint filter is as shown in
Figure 2, remove the filter by pulling it up.
3. Clean lint, fibre, and cotton raveling on the
filter and in the filter housing by hand or
with a soft piece of cloth.
er and place it back into its
4. Close the filt
seat.
18
C
NOTE
• Clogging may arise on the filter surface
after using your machine for some time; if
this occurs, wash the filter with water and
dry it before using again.

Cleaning the sensors

• There are temperature sensor in the
dryer that detect whether the laundry is
dry or not.
To clean the sensors:
• Open the loading door of the dryer.
• Remove the lint filter by pulling it up.
• Clean the sensor with your hand if any
fluff accumulation on it.
C
NOTE
• Clean metal sensors 4 times a year.
• Do not use metal tools when cleaning the
sensor.
• Allow the machine to cool down if it is still
hot due the drying process.
A
WARNING!
• Never use solvents, cleaning agents
or similar substances when cleaning
since these materials can cause fire and
explosion!
Dryer / User Manual