Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In order to use the device with the continuous water outlet connected, you should:
• Remove the water tank (7) (fig. 9).
• Remove the tank housing component (fig. 10).
• Slide a pipe (10) to the water outlet valve located in the upper section of the tank bay
(fig. 11)
• Slide the tank (7) in and lead the pipe out through the cut-out (fig. 12).
• Place the other end of the pipe into a container, e.g. a bucket.
Uwaga
Never bend the drain tube. The tube outlet must always be below the water outlet
from the device. Never block the water outlet from the device or the tube.
MAINTENANCE
Note:
Turn off the unit and unplug it before any maintenance or repair begins to avoid electric
shock.
CLEANING
Unplug the unit before any cleaning. Clean the housing with a soft moisture cloth. Do not
use chemical solvent (such as benzene, alcohol, gasoline). The surface may be damaged or
even the whole case may be deformed. Do not sprinkle water on the unit.
AIR FILTER
Clean the air filter every 2 weeks. If the air filter is blocked with dust, the efficiency will
reduce.
13
14
15
16
17
Filters must be pulled out of the housing (image 13,14), dismantled (image 15), then
washed in warm water (about 40 °C) using a neutral detergent. Rinse, dry thoroughly, and
then install.
Note: Do not operate the device without a properly installed filter.
EN|17
Werbung
Inhaltsverzeichnis
