Use; Charging The Battery; Operating Instructions Monitor - TRADIX IAN 305962 Bedienungsanleitung

GB/IE/NI
as shown in Fig. B1.
3
10. Place the mounting plate
11. Slide the mounting plate to the
Fig. B2). Tighten the fixing
Tighten the screws only by hand. Tightening too
much can damage the camera unit.
12. Insert the adapter of the camera unit into the
(see (1) Fig. C1).
on the monitor
1
13. Place the monitor
1
down (see (2) Fig. C2).
the monitor
1
Take care not to pinch the connecting cable. Oth-
erwise, the cable may be damaged.
If necessary, return it to the cavity behind the mounting
plate.
Your digital door viewing port is now mounted.

8. Use

Using the door viewing port
First insert the supplied 1000mA lithium-ion battery into
the battery compartment as shown and fully charge it
4
before using the digital door viewing port for the first time.
1. Slide the cover (a) to the right to open the battery com-
partment (see Fig. D1).
2. Insert the battery into the battery
shown (see Fig. D2).
Make sure to insert the battery
rect polarity!
3. Replace the cover (a) and slide it to the left to close the
battery compartment.
14
on the fixing screws
3
correct position (see
3
screws.
5
NOTE!
2
on the mounting plate
NOTE!
compartment as
4
according to the cor-
4
4. Insert the 4 GB MicroSD card (see Fig. E).
.
5

9. Charging the battery

Press the OK button
the bottom right of the monitor display. The battery symbol
indicates the state of charge of the battery.
If the symbol is red and starts flashing, the battery must be
charged.
socket
You may need to remove the monitor from the
adapter plate to charge the battery.
. Slide
3
1. Slide the monitor up
2. Disconnect the connection cable from the
3. Plug the supplied USB charging cable with the
plug into the socket on the monitor
4. Plug the USB connector into an appropriate device, e.g.
your computer.
5. When the battery is fully charged, install the monitor
as described in "7. Mounting" described again on the
mounting plate

10. Operating instructions monitor

The infrared LEDs switch on automatically in the dark.
1. Turn on the display with the On/Off
2. You can now view the live image of the camera on the
screen.
3. Press the shutter button
to display the battery symbol at
9
NOTE!
from the mounting plate
1
(see Fig. E).
1
.
3
NOTE!
switch.
13
to take a photo or video.
11
GB/IE/NI
.
3
monitor.
1
7 micro
1
(F)
15