Assembling; A: With An Existing Door Viewing Port; B: Without An Existing Door Viewing Port - TRADIX IAN 305962 Bedienungsanleitung

GB/IE/NI

7. Assembling

Door viewing port installation
The door viewing port is designed for the opera-
tion in interior corridors. Moisture and frost will
damage the camera unit.
If you do not feel confident enough to carry
out the assembly or disassembly yourself, then
commission a specialist company.

A: With an existing door viewing port

B: Without an existing door viewing port

1. Measure the thickness of your door leaf. The door leaf
must have a thickness between 35 - 100 mm.
A: With an existing door viewing port
2. Remove the existing door viewing port. This is usually
done by simply unscrewing the cover on the inside and
pressing out the counterpart.
3. Check the diameter of the hole. It must be at least 15
mm. If the diameter is smaller, drill the hole with a drill
to a diameter of at least 15 - 16 mm (see following
point B).
B: Without an existing door viewing port
2. A suitable hole must be drilled into the door leaf.
You will need a drill, a 16 mm drill (the type of drill
depends on the material of the door leaf) and possibly
a folding rule.
12
NOTE!
NOTE!
Before installing the door viewing port, ask
your house owner in advance whether a hole
may be drilled into the door!
! CAUTION!
No hole may be drilled in glass doors or doors
with glass inserts. The glass could be damaged!
3. Drill a hole at the height where you want to mount the
door viewing port. The hole should be located hori-
zontally in the middle of the door. The optimal height
is your eye level, or approx. 140 - 160 cm from the
floor. Mark the drill hole beforehand with a ruler and
a pencil.
4. Clean the drill hole, as it must be free of dust and
grease.
5. Use a Phillips screwdriver to screw the fixing screws
into the camera unit with a few turns.
Select two identical fixing screws according
thickness of the door leaf:
- 2.6 x 30 mm for door leaves from 35 - 62 mm
- 2.6 x 55 mm for door leaves from 64 - 85 mm
- 2.6 x 80 mm for door leaves from 85 - 100 mm
6. Stick two 3M adhesive strips
camera unit as shown (see Fig. B1).
2
7. Insert the camera unit
in the door leaf as shown. Carefully pass the connect-
ing cable through the hole.
8. Fasten the camera unit to the door leaf
3M adhesive strips. The camera unit must be aligned
so that the four infrared LEDs on the front of the
2
camera unit are level.
9. Pass the connecting cable through the mounting plate
NOTE!
on the back of the
8
from the outside into the hole
2
using the
2
GB/IE/NI
5
to the
5
8
13