3.
Alarm overtemperature setting
The temperature alarm is factory set to switch
to 1 ° C above or below the required
temperature. This setting is sufficient and does
not need to be changed.
Alarm for low temperature (AL)
3.1.
3.1.1. Press and hold SET button for 3s.
3.1.2. Press SET again and find „AL"
3.1.3. With " ↑ " and " ↓ " set the desired value
for switching on the low temperature alarm
High temperature alarm (AH)
3.2.
3.2.1. Press and hold SET for 3s
3.2.2. Press SET again and find „AH"
3.2.3. With " ↑ " and " ↓ " you can adjust desired
temperature
3.2.4. Press SET button to save and leave
Humidity alert setting
4.
The humidity alarm is factory set to switch on
45% humidity. This setting is sufficient and
there is no need to change it .
Humidity alert
4.1.
4.1.1. Press and hold SET button for 3s.
4.1.2. Press SET again and find „AS"
4.1.3. With " ↑ " and " ↓ " you can adjust desired
humidity value.
4.1.4. Press SET button to save and leave