H&O Equipments CryoPen M Gebrauchsanweisung Seite 13

The trocar of the opener should be pointed upward!
Take the cartridge and put it into the cavity with the narrow
side down, on top of the filter/opener device.
Regarding CryoPen X+/CryoProbe X+, CryoPen O/CryoProbe O,
CryoPen XP/CryoProbe XP if the cartridge is an 8g cartridge endow
the converter 16/8g.
Step 3 I Puncture the unused cartridge
Gently screw the CryoPen/CryoProbe's backend onto the front end.
Go to the point where you feel that the contact between the assembled
filter/opener device and the cartridge is established.
Now, position your hands so that the last turn will be in an uninterrupted
movement. Now, rotate quickly until you feel that the end of the rotation
is achieved. You may eventually hear a short hissing sound.
The shorter the hiss, the better!
Step 4 I Use your CryoPen/CryoProbe
Remove the applicator cap. Gently squeeze the trigger switch to start
the flow of N O. Release the trigger to close off the flow
2
of cryogenic liquid. 1 or 2 seconds after releasing the trigger,
the remaining gas in the applicator is discarded.
NO
YES
Installation of the assembled
filter/opener device
13