Vitek VT-1406 BK Betriebsanleitung Seite 6

ENGLISH
• If you press and hold down the "TURBO" but-
ton (3), the unit will operate at maximum rota-
tion speed.
•
After unit operation, set the operation mode
switch (2) to the position «0» and unplug the
unit.
•
Press the button (1) to release the installed
attachments (5 or 6).
Attention! Do not press the attachment
release button (1) during the unit operation.
Using the holding base (12)
To complete more difficult cooking tasks
you can install the mixer (4) on the holding
base (12):
Press the «RELEASE» button (10) and lift the sup-
port (9) until it is fixed in the upper position (pic. 3).
•
Place the mixer bowl (7) on the holding
base (12) (pic. 4).
• Install the scraper blade (8) in the mixer bowl (7),
matching the locks on the scraper blade (8) with
the grooves on the base (12) (pic. 5, 6).
•
Insert the beaters (5) or the dough hooks (6)
into corresponding mixer (4) sockets until
clicking. Both attachments should be fixed
properly in the mixer openings (pic. 1, 2).
Note: For proper assembling install the attach-
ment with a plastic gear (5 or 6) into the mixer
body (4) opening marked with a star.
•
Place the mixer (4) on the support (9) matching
the locks on the support (9) with the openings
on the mixer body (4) and press on the mixer
to actuate the locks (pic. 8). The plastic gear
on the attachment must match the opening in
the support (9) with installed plastic plug. Lift
the support (9) with the mixer (4) installed on
it having pressed the «RELEASE» button (10).
• Put the necessary ingredients into the bowl (7).
RECOMMENDED OPERATION MODES
Product type
Used attachments: beaters (5)
Beating egg whites
Whipping cream
Mixing ingredients for dough
Beating butter
Mixing butter with flour (if necessary, you
can add some water for getting doughy
consistency)
IM VT-1406.indd 6
• Press the «RELEASE» button (10) and lower
the support (9) with the installed mixer (4)
until it is fixed.
•
Insert the power plug into the mains socket.
•
Switch the mixer on with the operation mode
switch (2) and select the required attachment
rotation speed «1, 2, 3, 4, 5».
•
If you press and hold down the "TURBO" but-
ton (3), the unit will operate at maximum rota-
tion speed.
Attention! Be careful! During the mixer (4)
operation on the holding base (12) the bowl (7)
rotates and the mixer (4) with the support (9)
oscillates horizontally. Do not touch the rotat-
ing parts of the unit. Do not let hair or free
hanging clothes get into the rotation area. Do
not let foreign objects get into the bowl.
•
After unit operation, set the operation mode
switch (2) to the position «0» and unplug the
unit.
• Lift the support (9) with the mixer (4) installed
on it having pressed the release button (10).
•
Hold the mixer (4), then press and hold down
the release button (11) to remove the mixer
from the support (9) in the upward direction.
•
Press the button (1) to release the installed
attachments (5 or 6).
• Remove the bowl (7) from the holding base
(12) and take products out of it. To remove
the bowl (7) from the holding base (12) slightly
turn it counterclockwise and pull upwards.
Notes:
Maximal continuous operation time is no lon-
–
ger than 15 minutes; make at least a 30 min-
ute break before switching the unit on again.
Do not block the ventilation openings on the
–
unit body, this may lead to the electric motor
overheating.
Attachment
Recommended
rotation
product amount
6
300 ml
400 g
400 ml
150 g
6
Approximate
operation
speed time
4-5 2-4 min.
1-5 4 min.
1 - 5 1.5 – 2 min
4 - 5 1 min.
1-2 4 min.
1 1 min.
20.04.2016 15:58:00