Distribution Of The Hydraulic Oil - ULTIMATE SPEED HG01040 Bedienungs- Und Sicherheitshinweise

Before using the hydraulic vehicle jack take
precautions to prevent the vehicle from rolling
away. Put the handbrake on, place the vehicle
in gear (with automatic gearboxes set to "P")
and chock the wheels.
Even with safety measures in place always
remain alert and make a visual check that
the support plate
the vehicle jacking point.
Make sure that no petrol, battery acid or
any other dangerous substance can flow out
of the vehicle when the vehicle is being lifted.
Check that no person or object is under the
vehicle before you lower it.
Lower the vehicle slowly.
Check that all parts have been assembled
and fitted properly and are undamaged.
Before each use check that the hydraulic
vehicle jack is working properly. Check the
screws and valves of the hydraulic vehicle
jack for correct seating and look out for
hydraulic oil leaks in particular.
Never use the hydraulic vehicle jack for
moving or loading a vehicle. Never use it to
lift a whole vehicle completely off the ground.
It's not allowed to lift up people with the
hydraulic jack and make sure that near
located people keep enough distance to
the vehicle when the hydraulic jack is in use.
Never change the setting of the safety val-
ve . It has been set at the factory and must
8
not be adjusted. Stop using the product if the
safety valve setting is changed.
Before using the vehicle jack, the user must
be made familiar with the device by an expe-
rienced person. The pump force and the
transferred force are equal to approximately
380 N.
If the markings on the product are damaged
enough so as to be illegible then the vehicle
jack must not be used until the markings are
renewed.
No modifications may be carried out to the
hydraulic trolley jack. Any physical modifi-
cation of the device has an effect on the
safety of the device and its compliance with
EN 1494 / A1:2008.
6 GB/CY
is firmly seated against
3
The applied force when using the vehicle
jack must be lower 380 N. The equates to a
force on the lever of approximately 38 kg.
The operating temperature of the hydraulic
oil of this equipment is between -20 °C to
+40 °C.
Only use this device to lift and lower the
vehicle, not to keep the vehicle in a lifted
position. Do not move it whilst raising or
lowering.
After use return all parts used into their
original position. Have the hydraulic oil or
oil pump replaced by a professional if the
parts can no longer be moved.
If you notice a spillage of oil, stop using the
product and absorb the oil on the floor with
a cloth. Any reparation must be done by a
professional.
Before first use
Distribution of the
hydraulic oil
With the release valve
lifting handle into the lifting handle
1
socket . Use at least 6 firm pumping
6
movements to charge the hydraulic system
(move lifting handle
action distributes the hydraulic oil evenly.
Note: Check that the release valve
by inserting the lifting handle
turn it clockwise (see Fig. A). DO NOT OVER
TIGHTENED! When you cannot turn it any fur-
ther, the release valve
Using the jack
Raising the vehicle
With the release valve
lifting handle into the lifting handle
1
socket (see Fig. B).
6
closed, insert the
5
up and down). This
1
is closed
5
and trying to
1
is closed.
5
closed turn the
5