Safety Warnings; Product Description - Fracarro SIG7330 Betriebsanleitung

The product must be installed only by qualified persons, according to the local safety standards and regulations.
It is classified as Class II, in accordance with EN 60065 and, for this reason, it shall not be connected to the
protective earth (PE) of the supply mains. The product must be installed in an Headline Sub-rack and it must not
be connected directly with an external power cable.
Installation warnings
• The product must not be exposed to dripping or splashing and thus it shall be installed indoors, in a dry place.
• Humidity and condensation could damage the product. In case of condensation, wait until the product is dry
before using it.
• Don't install the product above or close to heat sources, in dusty places or where it might come into contact
with corrosive substances.
• Leave enough space around the product housing to ensure sufficient ventilation; an excessive operating
temperature and/or an excessive heating may affect the performance and the life of the product.
• To prevent injury, this product must be securely connected to a Sub-rack, in accordance with the mounting
instructions, given in Chapter 3.
In accordance with the European Directive 2004/108/EC (EMC), the product shall be installed using devices,
cables and connectors that allow to comply with this directive requirements for fixed installations.
Fracarro Radioindustrie SpA is not responsible for the possible network diffusion of the television signal de-
coded by SIG7330. The installer and the product user must follow the user conditions provided by the service
provider and those specified in the purchasing agreement of the "smart card".
Therefore, Fracarro Radioindustrie SpA is relieved from any civil or criminal responsibilities due to a breach of
juridical regulations in the matter and arising from any improper use performed by the installer, by the user or by
third parties.
Earthing of the antenna system
The Sub-rack, where the unit will be installed, must be connected, directly or through the rack, to the earth
electrode of the antenna system, in accordance with standard EN 50083-1, section 10.It is recommended to
follow the provisions of EN 50083-1 and not to connect the Sub-rack or the rack to the protective earth (PE) of
the supply mains.
IMPORTANT: Never remove the product cover, parts at hazardous voltage could be accessible when the prod-
uct case is opened. Only instructed and authorized persons can open the product. In case of failure, do not try
to repair the product; otherwise the guarantee will no longer be valid.
The SIG7330 module is a QPSK receiver to receive digital programmes from the satellite, both from the satellite
antenna and from the Transport Stream in the back panel. Furthermore, the distribution is available to both the
RCA output connectors of the audio video signal in the baseband or to the Transport Stream in the back panel.
Therefore, the unit can be installed stand alone to distribute only one programme through the RCA outputs or it
can be connected to the SIG7120 or SIG7720 modules, which take advantage of the Transport Stream transmis-
sion. Furthermore, it can manage subtitles and the WSS signal, which identifies the aspect ratio of the transmit-
ted video.
Every single module can generate 14/18V, a 22kHz tone and a DiSEqC
1.0 tone-burst to control multiswitches, if any, or LNB (max 400mA@14V
remote power feed).
The device is equipped with the following:
• 1 input RF connectors (SAT IN + DC) for SAT polarity input connection;
1 SAT loop-through RF connectors (SAT OUT);
• Operation and signal LED (see the summarizing table);
• 3 RCA connectors (Yellow -> Video output, White -> Audio Left, Red
-> Audio Right);
ATTENTION: the last pages of these instructions (TECHNICAL SPECIFI-
CATIONS) show the complete list of characteristics.

1. SAFETY WARNINGS

2. PRODUCT DESCRIPTION

15
SAT INPUT
RIGHT
AUDIO
OUTPUT
LEFT
AUDIO
OUTPUT
VIDEO
OUTPUT
OUTPUT
TO
OTHER
MODULES