Fracarro SIG7330 Betriebsanleitung Seite 21

5.2.1 TPE GENERAL MENU
Headend or device navigation
Emulation of the KTP
programmer
Confirm the settings by pressing the
pressing the S key after the modules programmation.
5.2.2 SIG7330 GENERAL MENU
Setting the input parameters
SIG7330
Setting the output parameters
Measurements of the input and
output signal
Confirm the settings by pressing the
pressing the S key after the modules programmation.
TPE settings
TPE SETUP
HEADEND SETUP
KTP EMULATION
key; save the settings by
INPUT
OUTPUT
MEASURE
key; save the settings by
21
TPE SETUP MENU
25
see page
HEADEND SETUP MENU
26
see page
KTP EMULATION MENU
26
see page
INPUT MENU
22
see page
OUTPUT MENU
24
see page
MEASURE MENU
24
see page