Fracarro SIG7330 Betriebsanleitung Seite 24

OUTPUT
Video format settings
Audio Output
adjustment
Audio Level
adjustment
Standard Output
video Adjustement
Confirm the settings by pressing the
pressing the S key after the modules programmation.
There is the OUTPUT menu on detail:
TS OUTPUT – To enable or disable the output Transport Stream on the back-panel.
RCA OUTPUT – To set the output RCA parameters.
VIDEO FORMAT – To select the output video format among Letter box, Pan and Scan, Combined or
Adapted 16/9.
AUDIO TYPE OUT – To adjust the output audio type among MONO, MONO LANG 1, MONO LANG 2 or STEREO.
AUDIO LEVEL – To adjust the output audio level with values from 0 to 10 (step 1).
STANDARD – To adjust the output standard video from PAL, PAL-N, SECAM-L,NTSC-M or PAL-M.
MEASUREMENTS
Bit Error Rate measurement of
the input signal
Signal to Noise Ratio
measurement of the input signal
Confirm the settings by pressing the
5.2.4 OUTPUT MENU
ENABLED
TS OUTPUT
VIDEO FORMAT Letter Box
AUDIO TYPE MONO
AUDIO LEVEL 0
STANDARD PAL
5.2.5 MEASUREMENT MENU
SOFTWARE VERSION
BER
S/N (dB)
pressing the S key after the modules programmation.
Enable/disable the Transport
Stream output from the back
DISABLED
16:9
MONO
MONO LANG 1
STEREO
MONO LANG 2
STEREO
10 0, 1, ..., 10
PAL
PAL-N
NTSC-M
PAL-M
SECAM-L
NTSC-M
key; save the settings by
SIG7330 vers. 0
1,3*10E-4
11
key; save the settings by
24
panel
Note: these video
Letter Box
formats are available
Pan Scan
only if the channel is
Combined
broadcast in 16/9
Adapted
Read-only
Read-only
1=not synchronized signal
Read-only
0=not synchronized signal