4
Remove the two screws and
washers from the cover plate
on the rear panel of the DSR-
60/60P. Slide the cover plate
to the right, then remove it.
Note
Retain the cover plate.
5
Feed the cable out through the
hole exposed when the cover
plate is removed, and connect
it to the connector panel, one
of the components of the
DSBK-110/110P.
6
Attach the connector panel to
the rear panel of the DSR-60/
60P.
Pulling the cable back through
the hole, slot the connector
panel into position, then slide it
to the left. Fasten the
connector panel with the two
screws and washers removed
in step 4.
Cover plate
Yellow connector
Connector panel
(Continued)
13