Status-Led - Niko 0-10 V Bedienungsanleitung

20. Analogue control module 0-10 V
Description
Up to three high-power dimmers can be connected to the Niko Home Control installation using the analogue control
module 0-10 V. Three dimmers with an analogue input of 0-10 V can be connected to the module.
Useful Niko reference codes: 05-711, 05-715, 65-410, 65-412, 65-416, 330-00701.
Overview
A B
G
F
550-00240
A. Screw terminals 1 -3
B. Screw terminal COM
C. Sliding contact
C
D. CHANNEL LEDs
D
E
E. Buttons 1-3
F. ADDRESS button 1
G. STATUS LED
Connect one dimmer per screw terminal.
Common terminal used for connecting the mass of
the dimmers.
The sliding contact is used for connecting the next
module, which means that the bus and the power
supply module are then also interconnected.
One LED per channel. The CHANNEL LED lights up
in TEST mode when the output is activated.
These buttons are used for activating or deactivating
each individual output. Please remember that the
activation or deactivation is only temporary as it will
be overruled by the next bus communication.
The function of this button is twofold. In addition to
the function described under "E" this button is used
for transmitting the unique address of the module
during the addressing phase while programming the
installation.
The STATUS LED lights up in TEST mode when the
module is connected correctly and is functioning
properly. If an error occurs, the LED will blink to
indicate an error code.
20. Analogue control module 0-10 V
119