Connecting The Cable - HP LTO Ultrium 6650 Kurzanleitung

about mounting methods and requirements, see
the server documentation.
Using screws that are too long
CAUTION:
can damage the tape drive. If necessary, use
the washers in the GENERAL MOUNTING
SCREWS screw pack for a proper fit.
Attach the alignment screws or mounting
hardware
If the server or enclosure requires alignment
screws, special rails, or other hardware, attach them
to the tape drive with the screws supplied with the
tape drive. See the instructions with the screw kit
for required washers or shims.
Example: Attaching server rails
Positioning the tape drive
1. If necessary, remove the blanking plate from
one industry-standard, 5¼-inch full-height drive
bay.
If cable access for the tape drive
TIP:
bay is awkward, it might be easier to
access power and other connections if
the tape drive is installed in the top bay.
You might need to move other devices
to lower bays to make the top bay
available.
2. Align the drive in the bay and then slide the
drive into the bay.

Connecting the cable

If you are installing the tape drive in an enclosure
using the cable that came with the enclosure, skip
this section and follow the instructions included with
the enclosure to cable the drive.
To connect the cable that came with the tape drive
to a server or enclosure:
1. Connect the combined SAS and power
connector to the tape drive port.
2. Connect the SAS connector without the cover
to the host port, which could be on an HBA or
on the controller board.
Leave the cover on the unused SAS connector.
3. Plug the power connector into the power supply
cabling.
Securing the drive
1. Slide the tape drive fully into the drive bay.
2. If the drive is secured with clips, verify that they
are engaged and that the drive is secure.
If the drive is secured with fasteners, use a
PoziDrive #1 screwdriver to secure the 4mm
M3 screws provided with the tape drive.
3. Cover any empty bays with blanking plates and
then replace the cover on the server.
Page 2