zopa DOLCE Bedienungsanleitung Seite 22

Leg Assembly
1. Locate the two rear upper legs.
Insert the screw into the threaded hole in the highchair frame
and rotate the leg clockwise until it is firmly tightened.
Do not over tighten. Repeat on the opposite side.
2. The highchair must resemble the image shown.
3. Locate the four lower legs.
Insert the screw into the threaded hole in the upper leg
and rotate the leg clockwise until firmly tightened.
Do not over tighten. Repeat with the remaining three legs.
4. Rotate the plastic covers at the lower end of the legs.
Before using the highchair, check that the covers are
turned so that their bottom surface is against the floor.
22